RheinhardtP
Lifetime Supporting Member + Moderator
Hey guys n girls,
I had a problem recently where i had a VLT-5000 communication to a S7-400 Siemens PLC. My PLC went into stop mode while the drive was running and the drive just carried on running. It was different to when you lose your connection on the bus(wiring ect. the VSD goes into VSD fault)... The bus was up but the Master was not scanning.
Does anyone know of a parameter setting/interrupt in the drive that would disable/stop the drive if this does happen again.
Kind Regards
Rheinhardt
I had a problem recently where i had a VLT-5000 communication to a S7-400 Siemens PLC. My PLC went into stop mode while the drive was running and the drive just carried on running. It was different to when you lose your connection on the bus(wiring ect. the VSD goes into VSD fault)... The bus was up but the Master was not scanning.
Does anyone know of a parameter setting/interrupt in the drive that would disable/stop the drive if this does happen again.
Kind Regards
Rheinhardt