Hi all. This is my first post. I'm looking for some help with the correct use of the latest WindLDR 5.3 RDX2 routine on an FC4A-C24R.
I'm trying to read a serial signal from a data logger that looks like this "TEST:0.0,1.0$$". The "TEST:" is the header, the "$$" is the tail. The serial signal goes out with a 9600 Baud Rate, and the delimiter is a ",".
I'd like to play with a test routine to drive PLC relays using the logic 1s and 0s sent out from the data logger, and build from there once I get the RDX2 routine to work. Thanks!
Rob
I'm trying to read a serial signal from a data logger that looks like this "TEST:0.0,1.0$$". The "TEST:" is the header, the "$$" is the tail. The serial signal goes out with a 9600 Baud Rate, and the delimiter is a ",".
I'd like to play with a test routine to drive PLC relays using the logic 1s and 0s sent out from the data logger, and build from there once I get the RDX2 routine to work. Thanks!
Rob
