Hello! I'm trying to connect MM420 to PC using STARTER software. All configuration step's on PC is OK, I think. But Starter enyweay doesn't recognize any connected hardware (MM420 in this case). Connection options: PROFIBUS (MM420) <-> COM (PC). Cable RS485 <-> RS232.
Profibus address on MM420 is configured.
Question is, is it necessary to configure any parametres on MM420 to rezlize connection or it's enough to set all parametres by default and STARTER should find the hardware.
Thanks. Valerijs.
Sorry for my english!
Profibus address on MM420 is configured.
Question is, is it necessary to configure any parametres on MM420 to rezlize connection or it's enough to set all parametres by default and STARTER should find the hardware.
Thanks. Valerijs.
Sorry for my english!