2 panelviews with slc5/04 on DH+

billyh · May 3, 2008

I have one panelview plus currently connected to a slc504 using DH+.
I've added another panelview plus but can't get it to communicate.
Do I need to set the panelview to a different node or address? It's been a long day and I'm just not seeing it.

Billy

bguinn · May 3, 2008

yes you have to give it a different node address. After doing so you should be off to the races.

geniusintraining · May 3, 2008

It should also crash the other node if its the same address.... mine did

billyh · May 3, 2008

bguinn,

thanks, but do I set this in the panelview config or with rsview?

Ken Roach · May 3, 2008

In RSLinx Enterprise (launch the configuration from within RSView Studio) you set the DH+ address in the Target Tab when you configure the 2711P-RN6 driver.

I think this is also accessible from within the terminal itself, but you want to change it in your source Studio project anyhow.

billyh · May 3, 2008

Thanks Gentlemen.

That did it.

Billy

I have another problem but will start another thread.

2 panelviews with slc5/04 on DH+

billyh

Member

bguinn

Member

geniusintraining

Lifetime Supporting Member + Moderator

billyh

Member

Ken Roach

Lifetime Supporting Member + Moderator

billyh

Member

Similar Topics