Help on PLC (-number) input to 4X register

shockenberry

Member
S
Join Date
Jan 2006
Location
Milan, Ohio
Posts
4
Help on PLC -number input to register

This is in a Cryogenics application... Type T Thermocouples...I have Wonerware 8.0 HMI and a Modicon PLC/Concept programming software; I need to send a negative number to the PLC for an "auto" set-point for a PID controller on a small heater power controller. The PID1 SP is from a Type T temperature element; the PV from a %4K holding register...

Any Thoughts?

Steve
 

Similar Topics

M
HOW to communicate with OPTIX and Mitsubishi's Q Series PLC?? PLEASE HELP ME
HOW to communicate with OPTIX and Mitsubishi's Q Series PLC?? PLEASE HELP ME
Replies
0
Views
39
MIIN
M
H
Allen bradley PLC MSG help
I have a network with 4 PLCs PLC1 is controllogix and PLCs 2-4 are compactlogix and they all need to communicate. The current way I have this...
Replies
8
Views
260
heatfireash
H
J
Help out a beginner with GE90-30 PLC in proficy?
So to start off: I have no experience with PLC's, but I'm good at figuring stuff out, but I need some help to know if my PLC is just dead in the...
Replies
2
Views
114
Jaycobie
J
P
Need help with AllenBradley PLC data type conversion
Hi guys, I have no experience when working with AllenBradley PLC, but I hope someone could clarify the result of multiplication shown in the...
Replies
14
Views
2,193
GaryS
G
D
Manually dobbing in plc outputs help please!
To quickly test a plc output which is wired to a relay do I dob a cable between the output and 24vdc+ source I.e something with 24vdc+ live such...
Replies
6
Views
692
parky
P
Back
Top Bottom