junkerjorg
Member
I am used to scaling in the SLC family, nice and easy! What are the steps to scale and analog input in a PLC 5? I assume you use the CPT statement but not really sure. Any help would be appreciated!!
Scaling in PLC 5/80
- Thread starter junkerjorg
- Start date
Ron Beaufort
Lifetime Supporting Member
Similar Topics
I want to measure the tank level and get the sensor output to the PLC. Below are the details :
Tank Height =0 - 3m, the sensor is stalled 0,2m...
Hello everyone, been trying to figure this one out for awhile now.
The system configuration is as follows:
Processor is an L63 5563 ControlLogix...
I’m trying to perfect the HMI interface for analog configuration. I’ve provided the user the same options for all analog inputs, as follows...
Hello All,
What Wil be the raw scaling range if I want to connect 0-1vdc humidity sensor.
Thanks
I need to scale a raw value into Engineering units.
i don't think there is a standard scaling block in PLC 5 instruction set (or i didn't see...