jason_guohua
Member
s5-13u plc system configuration are as follows:
1. 6es5923-3ua11
2. 6es5928-3ua12
3. 6es5922-3ua11
4. 6av1242-0AB10
5. 6es5525-3ua11
6. some digital and analog modules
Now I came into a big problem , according to multiprocessor operation procedure , both 928A and 922 cpu couldn't enter run state, stop LED on 922 cpu flash slowly and stop LED on 928A is lit continuously, BASP LED light up after switching on the power supply or Overall Reset. I don't know where is the fault ,hardware or software or others? pls give some help and suggestion ,thanks! otherwise, I have also caputured the detailed ISTACK information as the attached . in addition , user programs is loaded in EPROM on 928A and 922 cpu. this is a complete program .
[font=#23435#20307]
[font=#23435#20307][/font]your response is highly appreciated!
[/font]
1. 6es5923-3ua11
2. 6es5928-3ua12
3. 6es5922-3ua11
4. 6av1242-0AB10
5. 6es5525-3ua11
6. some digital and analog modules
Now I came into a big problem , according to multiprocessor operation procedure , both 928A and 922 cpu couldn't enter run state, stop LED on 922 cpu flash slowly and stop LED on 928A is lit continuously, BASP LED light up after switching on the power supply or Overall Reset. I don't know where is the fault ,hardware or software or others? pls give some help and suggestion ,thanks! otherwise, I have also caputured the detailed ISTACK information as the attached . in addition , user programs is loaded in EPROM on 928A and 922 cpu. this is a complete program .
[font=#23435#20307]
[font=#23435#20307][/font]your response is highly appreciated!
[/font]