btroxell
Member
I have two sensors that output from 0 to 5 VDC.
How do I process these input signals in an Eaton Logic Controller ELC-PV28. I need to take the voltage and multiply by 20. This number will then be used to determine if a coil turns on.
I am very new to PLCs so any help is greatly appreciated.
How do I process these input signals in an Eaton Logic Controller ELC-PV28. I need to take the voltage and multiply by 20. This number will then be used to determine if a coil turns on.
I am very new to PLCs so any help is greatly appreciated.