Ethernet communication cable configration
- Thread starter mvannantn
- Start date
In some cases, the NICs can figure out how to "auto-configure" MDI/MDIX by themselves.
But sometimes they cannot auto-configure. Putting a switch in between typically fixes it. Otherwise make your own crossed cable:
1-3
2-6
3-1
6-2
But sometimes they cannot auto-configure. Putting a switch in between typically fixes it. Otherwise make your own crossed cable:
1-3
2-6
3-1
6-2
Similar Topics
Hi Every one. A placeure to be here.
Now, would you tell me some information about it? Thank you.
I'm retrofitting equipment, but I didn't want to change the electrical characteristics of the panel. In this equipment I have a dedicated...
I have a contractor at my water plant installing 3 brand new Powerflex 7000 VFD's for my High Service pumps. I would like to control these via...
Hi All,
We are planning Establish communication between Power Energy Meter (Schneider PM5320) with Rockwell PLC. I am unable to get the Assembly...
Hi All ...
In one full plant, all machines are connected to networks.
above 500 ip address...
that consists of plc,servo,hmi and third party...
