Technifor Serial Comm

JOLTRON

Lifetime Supporting Member
Join Date
Aug 2006
Location
MI
Posts
692
I was wondering if anyone has any information on serial commands that can be sent to and from a Technifor UC112 or similar. I am currently sending part numbers and lot numbers to different variables in the Technifor but need to find a way to send the information back to make sure it updates. I have looked through the manuals that I have but don't see anything like it, but I know it's possible.

Has anyone worked with this kind of setup.

I have an email into there tech support but have not recieved an answer yet.

Thanks,
-Joel
 
It's a bit late to the party here but I did recieve information for the technifor/gravotech controller in my application. Ethernet/IP was not supported but serial comms and ethernet tcp/ip are. Attached are the manuals for reference.
 

Similar Topics

Hello Everyone Anyone have any experience with these? I have a customer with an existing one which needs some programs added but can't seem to...
Replies
1
Views
3,112
I have 9 field devices, three METSEPM5110 power meters and six ACE949-2 rs285 interface modules. I want to read this Modbus rtu data through rs485...
Replies
8
Views
269
I have lm9030 program on my toughbook CF-29 cannot get my program to hook up with the serial port.
Replies
2
Views
54
I have a project to setup base programs across multiple PLC platforms that can be used for Modbus communications to various sensors that have...
Replies
0
Views
98
Hello all, I am a college student currently working on my senior year engineering capstone project. As part of this project, I have been given an...
Replies
6
Views
204
Back
Top Bottom