yokogawa & s7 link

gh_ounie

Member
G
Join Date
Dec 2007
Location
aleppo
Posts
73
I went to setup profibus comunication linke between yokogawa Centum CS-3000 DCS and S-7300 PLc. DCS as a Master and PLC as slave by using ET200 .

I shall appreciate, if some one can send me step by step procedure to configure slave end.
 
Last edited:

Similar Topics

G
yokogawa controller with modbus tcp/ip communication with s7 1200 plc
can i send and recieve data using my yokogawa UT35A controller with my siemens s7 1200 plc using profinet communication without using gsd file
Replies
1
Views
378
Puddle
P
M
Yokogawa Rotamass Flow meter
I need modbus communication tool for Yokogawa Rotamass Flow meter? can any one help me.
Replies
1
Views
978
Keystone
K
S
Wiring yokogawa transmitter to schneider analog module tm3ai4
Hi, i'm working with a differential pressure transmitter yokogawa EJA130E and have problems to connect it to a Schneider analog module TM3AI4...
Replies
2
Views
2,053
BryanG
B
maharshicool
Yokogawa Software
Hi All, I'm currently working on Vulnerability signature of ICS software and i'm need of few Yokogawa software. The need is only setup file...
Replies
0
Views
1,736
maharshicool
maharshicool
K
how to use WiFi between Fast/tools yokogawa & STARDOM RTU
we have Fast/Tools at Control room to monitoring oil wells (RTU STARDOM) the Media Communication was CDMA Modem , Now we want to use the Wi-Fi...
Replies
0
Views
1,092
khlid11
K
Back
Top Bottom