Wonderware Woodhead Siemens comms

odonnea2

Member
Join Date
Oct 2006
Location
Dublin
Posts
17
I have a Siemens S7 CPU412-2 with an CP443-1 ethernet card. On a PC we have installed Wonderware SCADA software with a Woodhead Direct Link PLC Communication driver. The Woodhead I/O driver uses a parallel port license key (A sentinel driver is used to tie the Woodhead software license to this hardware dongle).

My problem is that I have been getting intermittent communication problems between the PLC and SCADA. The whole system has been up and running with the current configuration but after a recent reboot of the PC we have lost comms (and cannot see any live data on the SCADA graphic).

The Communications on the PLC ethernet card look fine
LEDS TXD and RXD are flashing green.
The link on Port 2 of the card (where the ethernet cable is installed) is solid green and the RX/TX LED is flashing.
Similarily the comms on the PC ethernet card are good and the ethernet connection is enabled and running.
No dirver settings have changed.

I have tried rebooting the PC and cycling power to the PLC but have had no luck.
Does anybody have any experience with this type of setup?
Thanks in advance
 
Thanks...
As it turns out this was an issue with the PC name. The original vendor PC had been replaced with a standard company PC. The original vendor PC had the name SCADA, while the new PC was named something else. The AccessName in Intouch is configured with the node name SCADA, and it was unable to resolve this name to the local PC IP address. When I added the IP address and the name SCADA to the Windows host file, communnication was re-established between Wonderware and the I/O Server.
I am still not too sure why communications were okay before I had the aforementioned comms problem however.
 

Similar Topics

Hi, We are setting up an Aveva Plant SCADA node with the intention to connect it to a Wonderware Historian node. Everywhere I look online I see...
Replies
1
Views
120
Hola chicos. Tengo un problema con el driver de comucicacion dasabcip 5, y un plc controllogix v34, ya realice la comunicacion pero en ciertos...
Replies
2
Views
103
Hi, I am upgrading a Wonderware SCADA form version 9.5 to version 23. I am able to migrate all the graphic, but when to activate the runtime this...
Replies
8
Views
339
Hi all, I am using OI.GATEWAY.2 to communicate to the PLC using an OPC UA. I can see the tags using an OPC explorer connecting to the...
Replies
0
Views
129
A project recently went through to replace an old computer that was running Wonderware with a new computer. After a bit of work I was able to get...
Replies
7
Views
403
Back
Top Bottom