Manual for a PMD150

kroml8r · Nov 2, 2008

Hi,

I have an old Uticor PMD150 programmeable message display. I am not sure if I need special software to set up the comms and messages or if it will just display serial messages as they arrive.

Does anyone have a manual for one of these? I reckon it was probably manufatured in the early 90's.

Thanks

jstolaruk · Nov 2, 2008

Register at the Uticor website and check out the download section. I ran into the same situation a couple of years ago and IIRC I was able to download the manual and possibly the s/w. However, tech support for the old units was not available.

If you don't have any luck, post back here and I may be able to dig up the s/w and manual for you when I return to the office.

kroml8r · Nov 3, 2008

jstolaruk

Thanks for replying,

I did register at the Uticor site and have successfully downloaded the software for the device. I could not however find a manual.

If you can find one and upload it, I would be very grateful.

Thanks

jstolaruk · Nov 3, 2008

I'm sorry, I was unable to locate the manual. The last project was to replace the Uticors with Panelview+s and it appears the manual did not survive.

diat150 · Nov 3, 2008

all I have is a uticor pmd200 manual. if you think that may be of some help to you post a email address and I will send it to you.

kroml8r · Nov 3, 2008

diat150

Hi,

jstolaruk, Thanks for trying.

diat150,

I am sure the manual for the 200 will be a big help.
[email protected]

Thanks.

diat150 · Nov 3, 2008

just sent it your way.

Manual for a PMD150

kroml8r

Member

jstolaruk

Lifetime Supporting Member

kroml8r

Member

jstolaruk

Lifetime Supporting Member

diat150

Lifetime Supporting Member

kroml8r

Member

diat150

Lifetime Supporting Member

Similar Topics