Proface TP interface using RS-485

muthu_buddy

Member
M
Join Date
Feb 2007
Location
Singapore
Posts
17
I have a new project which requires interfacing a touch panel with Mettler Tolledo Weighing Controller (IND580) & Danfoss inverter (VLT series). I want to interface the COM1(configures as RS-485) port of Proface GP3000 series with the IND560 & Inverter. Is it possible to this kind of interfacing without need to write any coding on the Proface TP. Did anyone did this beofre. If so please give me some suggestions. I don't want to use Profibus/devicenet/modbus card on the Touch panel as it would increase my cost very much.
 

Similar Topics

M
Siemens S7-314 MPI interface with Proface touch panel
I am new to using the Proface touch panel. Currently for a project i need to link a Siemens S7-314 PLC with the Proface 5.7" Touch panel...
Replies
2
Views
7,198
muthu_buddy
M
J
Proface Terminal software & cables
Hi all, i have several Proface GT2400 terminals and i need to get the software and interface cables and i have several questions. I am assuming...
Replies
3
Views
179
mikeexplorer
M
T
Proface HMI Send Emails
I have followed the videos & still having issues getting the email out. Does anyone have knowledge or has sent an email notification via gp pro ex?
Replies
0
Views
205
TiredPlc
T
A
Schneider M172 & Proface HMI
Has anyone found a Proface HMI that is compatible with Schneider M172 PLC?
Replies
0
Views
410
AB_PLC
A
E
Cannot open QuickPanel Proface project in QuickDesigner 3.7
Hi, I received the following project from a customer on a QuickPanel Proface 6" that I need to swap to a Siemens Panel. However, I cannot seem to...
Replies
3
Views
366
Steve Bailey
Steve Bailey
Back
Top Bottom