I have a slc 5/03 that crashed. I had the guys send me the equipment and found that the eprom had the program stored. I went to go online with the processor and it allowed me to restore the config off of the eprom into the processor since the fault had dumped the memory. My question is, in the case of a fault that dumps the memory, is there anyway to make it reload the program off of the eprom using the keyswitch? this seems like a lazy question but the processor didnt have the keyswitch with it and I will give it a shot with my spare keyswitch tomorrow(which I didnt have with me), just wanted to see if it was possible to do a reload via keyswitch instead of by software. thanks.