AS-i device configurator

Is it the one that looks like a DMM with display at top and a rotary switch in the middle and a M12 socket at the bottom, the 3RK1904-2AB01 ?

It looks like I can plug in a single device, program (set up) it's address, look at its state, not needing an external power supply.
 
Yes, that's a good one.

You can do everything that you stated with it. You can connect up to a slave without it being powered up and change the node address and view the configuration.

If the node is on an active network, you can view its status, ....
 
I found the Siemens one to be garbage, threw mine in the bin and bought a Gossen Metratest 36A. Not sure mine is still a current model. I had trouble with the siemens unit that it wouldnt power some of the nodes i was commissioning however the gossen unit worked a treat, also has software (WinProfi) to save the commisioning data for the network etc etc

Heres the spec sheet for the 36A which i also found far superior and easier to use than the Siemens one, there was a bit of a difference in price though !!
 
Last edited:
We did a few ASI bus systems. You do get a hand held ASI configurator. Never been tested, to my knowledge, so I would not trust it. Why ASI bus, not very integratable with major role players.
 
ASI bus is not a Siemens product. It is a a 3rd party involvement. Unless fully integrated by the OEM. Any one of the current OEM's.
 

Similar Topics

T
Emerson AMS Device Configurator will not recognize Viator modem?
I purchased a Viator HM-PF-USB-POWERX HART modem specifically because I was told it worked with Emerson AMS Device Configurator. But, Device...
Replies
0
Views
449
timothy585
T
A
Device net configurator
Hi. Does any one have the cable details ie pin to pin for an Allen Bradley 2702-DNC. It is a devicenet configurator that uses a common port to...
Replies
3
Views
4,464
MHennel
M
L
Using RAs IO Device Library with 1576-ENBT
Hi, I'm trying to use the IO Device Library (Product Versions) which is configured to work with the 1756-EN4TR & 1756-EN2TR but my system uses...
Replies
0
Views
59
LabRat906
L
D
Siemens PLC download with IO device
Hey guys, I have to take an upload of a program on an S71200 PLC to change a hardware config option and then redownload the program with this...
Replies
3
Views
111
JesperMP
JesperMP
W
Rockwell CIP messaging with a 3rd party device
Hi, First time poster, long time reader. I've got a mass flow controller device for controlling the flow of gas. It has a flowmeter and an...
Replies
4
Views
274
widelto
widelto
Back
Top Bottom