boswellw
Member
Hello all,
I am trying to connect to an OP17 panel to perform a download of the updated program. However, I cannot seem to change the baud rate of the IF2 port. It is currently set to 187.5 kb/s, and my Protools configuration will not allow me to set it's baud rate higher than 38400. I can change the baud rate to 19.2 on the panel's IF2A/B configuration, however when I press enter (or any other key for that matter) it just defaults back to 187.5. I'm sure I'm just doing something stupid, but I cannot find any information on this in the manual. Can anyone help me?
I am trying to connect to an OP17 panel to perform a download of the updated program. However, I cannot seem to change the baud rate of the IF2 port. It is currently set to 187.5 kb/s, and my Protools configuration will not allow me to set it's baud rate higher than 38400. I can change the baud rate to 19.2 on the panel's IF2A/B configuration, however when I press enter (or any other key for that matter) it just defaults back to 187.5. I'm sure I'm just doing something stupid, but I cannot find any information on this in the manual. Can anyone help me?