Pleaaseeeeee heeeeelp me.,,..,.,,..,

Heloo,.,

i got some urgent case in here can someone help me??
there any one know how to set Ethernet module in Mitsubishi PLC,.,
Please give me some clue.,.,.,,.

my configuration for PLC system :
1.[FONT=&quot] [/FONT]Base Plate using Q312B
2.[FONT=&quot] [/FONT]Power Supply module Q62P
3.[FONT=&quot] [/FONT]CPU module Q02HCPU (Main slot)
4.[FONT=&quot] [/FONT]Ethernet module QJ71E71-100(Slot 1) using XY0000-001F
5.[FONT=&quot] [/FONT]Input module QX41 (Slot 2) using XY0020-003F
6.[FONT=&quot] [/FONT]Input module QX42 (Slot 3) using XY0040-007F
7.[FONT=&quot] [/FONT]Output module QY40P (Slot 4) using XY0080-008F
8.[FONT=&quot] [/FONT]Output module QY41P (Slot 5) using XY0090-00AF
9.[FONT=&quot] [/FONT]Analog Input module Q68ADI (Slot 6) using XY00B0-00CF
10.[FONT=&quot] [/FONT]Analog Input module Q68ADI (Slot 7) using XY00D0-00EF
11.[FONT=&quot] [/FONT]Analog Input module Q68ADI (Slot 8) using XY00F0-010F
12.[FONT=&quot] [/FONT]Analog Input module Q68ADI (Slot 9) using XY0110-012F
13.[FONT=&quot] [/FONT]Analog Output module Q64DAN (Slot 10) using XY0130-014F
This system shouldn’t have a problem but I having a problem in connection Ethernet module to PC for monitoring system which we provide.
The monitoring system using LabView software.
Actually, I can Ping this device from Command Prompt in windows but can’t Ping in Melsoft or GX developer software.
I would like to know how to setting this Ethernet module and what protocol communication exist in Melsoft software for Labview user. Can you help me and give some guiding for this problem?

Pleaaseeeeee heeeeelp me.,,..,.,,..,

If you can ping it then you've setup the IP correctly. But have you gone into "Open Settings" to configure the connections? You have up to 16 possible connections that you can configure. But you need at least one setup to connect with the programming software.

It will depend on what the other app requires.
I connected kepware to a Q but could not get it to talk, I eventually set a UDP block in the setup of the QJ71 & used UDP It worked ok.
I contacted kepware & they informed me that UDP was the way to go, melsoft is usually only used for mitsi products like MX component or their own OPC driver.