JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
FX3U ethernet com. problems
Hey, I've som problems with the PLC to communicate through a router or switch using an
FX3UENET module. When I connect directly to my PC, it work out smooth. But communication through the switch causing an unstable communication. Pinging the PLC through the switch gives different results. Looking forward to some good advice! Thanks
FX3U - Ethernet module - Beiger 1151hmi
I have these setup on a press which all worked fine. But since swapping the FXU3-80 for a smaller FXU3-48...
Dear all,
I am using an FX3u PLC along with an FX3u-ENET-ADP card and the card is connected to a PC which runs kepServer 5.19
Is there a way for...
Hi,
I am working on Mitsubishi PLC project.I am using two PLC below.
PLC 1 - FX3U (Master)
IP : 192.168.0.10
PLC 2 - FX3g (Slave)
IP ...
Wonder if some1 can help me.
Im busy with a project and using a FX3U plc with a FX3U-ENET-L ethernet controller connected to a Beijer E1071 HMI...
My setup is as follows:
FX3U PLC with ENET module. IP address 192.168.100.201. Have a Melsoft connection set for connection 4.
Router: LAN...
