halburgepramod
Member
- Join Date
- Jun 2005
- Posts
- 54
Hello All,
We are using FTalkView-Studio Ver 5.0 / CPR-9.
1) We have created an Event file. The Expression written is:
If system\Time == "11:55:55 PM" Then 1 Else 0
The Action for above Expresson is : AppStart "C:\Documents and Settings\Desktop\Projects\Project1.exe"
In Event File "Enabled" option is selected.
In Starup Macro "EventOn EventFileName" is written. During runtime in Diagnostics List we get message that the Event File is running and the Action is Executing. But in fact the Action does not run the EXE file.
In fact no event file is running. Even in Commandline EventOn doesnot run this EXE file.
2) Like RSView-32 has VBAExec / VBAEdit commands, is there any command to run VBA Code in FTView-SE?
Any Suggestions / Solutions are highly appreciated.
Best Regards,
Pramod Halburge
We are using FTalkView-Studio Ver 5.0 / CPR-9.
1) We have created an Event file. The Expression written is:
If system\Time == "11:55:55 PM" Then 1 Else 0
The Action for above Expresson is : AppStart "C:\Documents and Settings\Desktop\Projects\Project1.exe"
In Event File "Enabled" option is selected.
In Starup Macro "EventOn EventFileName" is written. During runtime in Diagnostics List we get message that the Event File is running and the Action is Executing. But in fact the Action does not run the EXE file.
In fact no event file is running. Even in Commandline EventOn doesnot run this EXE file.
2) Like RSView-32 has VBAExec / VBAEdit commands, is there any command to run VBA Code in FTView-SE?
Any Suggestions / Solutions are highly appreciated.
Best Regards,
Pramod Halburge
