prolinx etherNET to modbus IP

goekgoek

Member
G
Join Date
Jul 2003
Location
kudus
Posts
11
hi, this is my first time to handle this prolinx. can anyone help me how to configure the mapping between the address of AB and the address of modbus IP device, step by step, or please send me an configuration example to my email [email protected]

the module is 5201-mnet-dfnt.

thank you
 
thank you mickey,

could you tell me the steps to configure and connect the module.
i realy.. realy blind on this subject.

thank you
 
Sorry I have not used that module.
But Prosoft manuals are usually pretty good.
Call them their support is even better.
 

Similar Topics

P
Prolinx 5210-DFNT-DNPM
Hi All, I’ve sort of been thrown in the deep in of a commissioning project and one of the areas I have no experience in is a Prolinx...
Replies
0
Views
1,744
pdsdownunder
P
C
No connection between PLC-5 + 1785-KE and Prolinx Gateway
Hello PLC Forum, I have an AB PLC-5 with a 1785-KE (DH+ to serial) modul. The PLC-5 channel 0 is used for point-to-point connection to HMI. The...
Replies
8
Views
2,960
cts_user
C
B
SLC 5/05 MSG (Read/Write) to/from ProLinx PDPMV1 Profibus Gateway
Hello, New to the forum here, and to the controls industry. I am trying to do the following: Read and Write to a 5204-DFNT-PDPMV1 ProLinx...
Replies
0
Views
1,880
bardo9
B
N
Debug Cable with connector for Prosoft make Prolinx Module (Cat: 5201-MNET-DFNT)
Can you please provide the pin-out diagram for following; which is used for Debugging of Prosoft make Modbus EtherNet TCP/IP module cat...
Replies
0
Views
2,530
nirmitpanchal
N
B
panelview plus 1500ce 6.0 to plc5 through prolinx
Has anyone ever used the New PV with 6.0 to communicate with plc-5/60 RIO? I was told we were to use the Prolinx module. So far NO good. Are we...
Replies
7
Views
2,841
bbseay
B
Back
Top Bottom