OMRON ZEN external relay question
- Thread starter gkp741
- Start date
gtsuport
Member
From the ZEN manual (see attached):
NOTE: There is a typo in the manual. It reads input, but this is from the output section and wiring indicates output.
NOTE: There is a typo in the manual. It reads input, but this is from the output section and wiring indicates output.
Similar Topics
I am very new so I will try to give as much information as possible. I cannot get a Prolific PL-2303TA USB to RS232 to connect to an Omron ZEN...
Hi, after 30 years involved with automation I'm actually writing my first PLC program and am struggling a fair bit. My background is mechanical...
Hi
I am setting a system up as per the attached picture, 5 inputs that are always present.
These are sensors I have in an injection mould, if...
Hello all, new on here, and relatively new to plc programming.
I am trying to write a program which counts as it receives a cycle end input, and...
I am trying to write a program for a omron zen plc.
1st light on for 30 sec
2nd light on for 12 sec
3rd light on for 3 sec
then start all over...