Siemens LOGO!OBA6
- Thread starter minaykha
- Start date
panic mode
Member
the installation instructions should be with the software.
do you have programming cable? there are two versions:
6ED1057-1AA00-0BA0 is for RS232
6ED1057-1AA01-0BA0 is for USB
USB cable will need driver installed.
do you have programming cable? there are two versions:
6ED1057-1AA00-0BA0 is for RS232
6ED1057-1AA01-0BA0 is for USB
USB cable will need driver installed.
Similar Topics
Hi all,
First, thank you for reading the thread. So I had a task as the following:
An up-counter must be programmed as part of a batch-counting...
Hi Lads,
I want to implement a flood prevention system with my domestic water pump.
The intention is to have the water pump cut off on a daily...
We need a Really Simple and Cheap controller that has a display or a Web Interface where we can change some set points.
We were thinking about a...
hello i have LOGO! 12/24RCE and i am looking for a schematics of electronic board. Or if someone know what is the burned component on the photo.
Hi,
I'm no expert in PID regulating so I need some advise.
I have a VFD controlled deepwaterpump that is maintaining the pressure in a closed...
