Modulus instruction for PLC-5/40
- Thread starter RBeta
- Start date
If you haven't got the mentioned processor, and hence not got MOD, then:-
Put a LBL on the rung, then a SUB, subtract your MOD divider once.
On the next rung, test to see if the result is greater than the divider, if it is, JMP back to the LBL
Put a LBL on the rung, then a SUB, subtract your MOD divider once.
On the next rung, test to see if the result is greater than the divider, if it is, JMP back to the LBL
Hi there,
One alternative might be to use a gateway. There are several out there.
http://www.anybus.com/support/support.asp?PID=105&ProductType=Anybus Communicator
//Pat
One alternative might be to use a gateway. There are several out there.
http://www.anybus.com/support/support.asp?PID=105&ProductType=Anybus Communicator
//Pat
Similar Topics
I have to commision a servosystem with S120 Epos function.
It concerns a continuous rotating chain that has pusher connected to it. The position...
Hi there,
I'm struggling with a project right now that involves collecting data from power meters in load centers. The data format is Modulus 10...
Note to all I found a major problem with the RSLogix modulus operator. If you take the modulus of a negative number in RSLogix the result gives...
Does this instruction calculate values during a single scan, or does it require number of scans based on element count in the array? For Example...
Hello All,
Was hoping I could get a little help with Modicon ladder logic. This is the first time I have seen Modicon logic and currently trying...