First, I don't want ppl thinking this is the same as my other thread as this is for the Logic side and the other was setting it up. Can anyone assist me in the basic rungs that need developed to control a Stepper motor in the RS Logix 500? I am using the PTO instruction to control the SureStep motor.
Micrologix 1500 and Stepper motor
- Thread starter Gig Jr
- Start date
Similar Topics
I have been working on this for a while now and I can't seem to get it. I was finally able to view the 1500 on the PanelView under the serial...
Hello, I have a 1764 1500 LSP Series A that keeps failing with DTL_E_FAIL I/O error. Searching around it seems there's a weird issue specifically...
Good Day
i Have Micrologix 1500 LSP, and I want to get data from plc and send it through Modbus RTU slave; I have only ch0 on that plc
I Order...
Hello folks,
Hope everyone is doing fine.
I got an OMRON NS10-TVOOB-V2 hmi screen last day and planning to use it with Micrologix 1500.
1. Is...
Good morning to all,
I need to modify an existing PLC MIcrologix 1500 configured with a Modem on Channel 1 (DF1 Full Duplex) and an...
