Hello
I am trying to get connection between old Telemecanique TSX47-411 (or TSX 87-425) with Siemens HMI. Protool and WinCC Flexible manuals say that it is possible using Unitelway bus and SCA62 junction box. But manual 6AV6596-1MA06-0AB0 (Communication for Windows-based Systems: Part 2, page 18-2) says:
- Tx: controlled via RTS
Does anybody has experience with that kind of communication? What is these Moxa cards for? This is PCI card and I do not see where this should be installed.
Best regards,
macio
I am trying to get connection between old Telemecanique TSX47-411 (or TSX 87-425) with Siemens HMI. Protool and WinCC Flexible manuals say that it is possible using Unitelway bus and SCA62 junction box. But manual 6AV6596-1MA06-0AB0 (Communication for Windows-based Systems: Part 2, page 18-2) says:
" For connection of the operating unit, an RS 485 interface card configured as
follows must be used:
follows must be used:
- Rx: always on
- Tx: controlled via RTS
Tests performed by Siemens AG involved the use of interface cards of the type
C102, CI 132, CI 132I or Ci 132IS from Moxa Data Communication Solutions."Does anybody has experience with that kind of communication? What is these Moxa cards for? This is PCI card and I do not see where this should be installed.
Best regards,
macio
