RTD/TC Multiplexor

bwheat

Member
Join Date
Sep 2003
Location
LA
Posts
174
I need to replace an obsolete thermocouple and RTD mux system. There are four of these with 32pt each. Three of them are T/C and one is RTD. The mux's are installed outside in a fairly harsh environment. Conformally coated would be preferable. I would like to go with some type of modbus TCPIP setup where I can pull the data back to a server and then push it to my DCS. Anybody used something like this before that worked well.
 

Similar Topics

Good Morning , I have a RTD , that I would like to wire into a 1756-IF8 Analog Input Card. Would you all a simple wiring diagram , of what...
Replies
4
Views
1,134
Good Afternoon , It seems like we always have problems with using Type J Thermocouples with our slip rings . Would using a RTD at 10...
Replies
6
Views
1,622
We are running a power flex 70 connected to a Delta V and I cannot get the drive to start because I am getting a STOP ASSERTD message on my HMI. I...
Replies
4
Views
2,806
I am working on an installation that will require sensor cabling interconnecting sensors to PLC subject to outdoor temperatures. Will the ambient...
Replies
3
Views
2,040
Hello! I have RTD sensor with 4 wire and shield ( 2 red wire + 2 white wire + Shield) and I want to connect to 1734-IR2 module. But in the manual...
Replies
2
Views
1,372
Back
Top Bottom