Toshiba - PU235N

deanb

Member
D
Join Date
Jun 2009
Location
Pennsylvania
Posts
1
I am trying to set-up ethernet communication to a Toshiba PU235N driver(PLC). It appears that I have properly set-up the IP address, as I am able to ping the IP address I have created for it. I am using kepware software to talk to the driver. In doing the kepware diagostic, I am not receiving any information packets back from the Toshiba driver.

Any suggestions on what to look for would be greatly appreciated.
 

Similar Topics

M
Toshiba G3 Can't access to menu parameters trohugh lcd display
Hi, I have two Toshiba G3 Tosvert-130, one of them I can see monitoring mode, I can control with the LCD display, recently I changed the presets...
Replies
1
Views
345
JeffKiper
JeffKiper
OkiePC
ML1500 to Toshiba VF AS1 via Modbus RTU
I inherited a system with the Micrologix 1500 talking to 8 VFDs using Modbus RTU protocol. One of the VFDs was replaced with a Toshiba VF AS1...
Replies
1
Views
1,202
OkiePC
OkiePC
P
Toshiba EX100
Another software thread! We have a Toshiba EX100 that's just been working away quietly in a panel for 20 years, never causing a problem to...
Replies
1
Views
1,202
kennadrin
K
J
Toshiba VF-S11
Hi, Any body had success to change parameters in between a Toshiba Inverter VF-S11 using a Red Lion any series (mine is K304), and MODBUS RTU...
Replies
1
Views
1,152
goghie
G
ganutenator
I'm loving the Toshiba drives
So far, the Toshiba drives seem to be the best out there. I wish their software was a little better though.
Replies
6
Views
2,028
BITS N BYTES
B
Back
Top Bottom