WINNCC Flexible

paulcamborne

Member

P

Join Date

Jun 2007

Location

ellesmere port

Posts

11

• Jun 15, 2009

• #1

Can someone help me.
When I open winncc flexible I do not have a toolbar to open or create a new project.
I have not used this software yet so am new to it.
Have been banging my head all day over this.

 

seppoalanen

Member

Join Date

Jan 2003

Location

Finland

Posts

1,132

• Jun 15, 2009

• #2

On the top, left side is Project, start from there.

 

paulcamborne

Member

OP

P

Join Date

Jun 2007

Location

ellesmere port

Posts

11

• Jun 15, 2009

• #3

Hi. Thanks for the reply.
But you misunderstand the problem.
I have no toolbar at all at the top of the screen when I open wincc.
Ciao.

 

TurpoUrpo

Lifetime Supporting Member

T

Join Date

May 2008

Location

Switzerland

Posts

1,571

• Jun 15, 2009

• #4

take screenshot at post it in here so we can actually see

 

paulcamborne

Member

OP

P

Join Date

Jun 2007

Location

ellesmere port

Posts

11

• Jun 15, 2009

• #5

Here is a screen dump of the opening wincc screen.

View attachment Screen Dump.doc

 

TurpoUrpo

Lifetime Supporting Member

T

Join Date

May 2008

Location

Switzerland

Posts

1,571

• Jun 15, 2009

• #6

In your case, i would very much try to install it again, looks like it does not load properly. Maybe contact siemens support.