JLDrescher
Member
Have a CTC/Parker PS10 Model HMI, Going To Use Comm-2 [RS485] On PS10,
Configured w/ ABDH SLC5/1 Network Driver. [Interact Shell Installed]
Allen Bradley SLC5/03 OS302, Want To Use Channel-0 [RS232],
Already Configured For DH485.
Found Wiring Info From CTCUSA; CTCSP10 Comm-2 To SLC5/03 Ch-1, RS/DH485.
No Luck Yet W/ AB.Com, Literature Library, 1747-L532, ect.
To Date Have Not Located Wiring For Channel-0 Communication Application.
CTCUSA Is Closed Until 06Jul09, Found Nothing Related In Forum's.
Need 9-Pin D-Shell Cable Wiring To Try and Establish Communication's
Any/All Information Would Be Helpful.
Software Spec's:
Machine Shop Release 1.04
Machine Logic Release 2.11 Build 238
Interact Release 6.1
Allen Bradley RSLogic 500 7.10.00 [CPR 7]
RSLinx Classic 2.50.00.20 [CPR7]
This Is a Home Project, Trying To Keep My Investment Cost Low,
1st Time Communicating w/CTC HMI, No Problems w/AB Pnlviews.
Processor Network Running, PC=Node 0, SLC5/03=Node 1,
CTC PS10 Programmed, Loads. Still Working w/Tag Editor.
Method Of Madness vs Time, Been Wrong Before.
Most People Use Ch-0 On SLC5 For PC-Comm, I'am Using
1747-PIC On Ch-1 Cause I Still Have It and Not Sure About
Max Cable Lenght Restriction On Ch-1 RJ495/CAT Cable's,
Easier To Frabricate D-Shell's.
CTC HMI Located Aprox +20Ft From Processor
Thank You.
Configured w/ ABDH SLC5/1 Network Driver. [Interact Shell Installed]
Allen Bradley SLC5/03 OS302, Want To Use Channel-0 [RS232],
Already Configured For DH485.
Found Wiring Info From CTCUSA; CTCSP10 Comm-2 To SLC5/03 Ch-1, RS/DH485.
No Luck Yet W/ AB.Com, Literature Library, 1747-L532, ect.
To Date Have Not Located Wiring For Channel-0 Communication Application.
CTCUSA Is Closed Until 06Jul09, Found Nothing Related In Forum's.
Need 9-Pin D-Shell Cable Wiring To Try and Establish Communication's
Any/All Information Would Be Helpful.
Software Spec's:
Machine Shop Release 1.04
Machine Logic Release 2.11 Build 238
Interact Release 6.1
Allen Bradley RSLogic 500 7.10.00 [CPR 7]
RSLinx Classic 2.50.00.20 [CPR7]
This Is a Home Project, Trying To Keep My Investment Cost
1st Time Communicating w/CTC HMI, No Problems w/AB Pnlviews.
Processor Network Running, PC=Node 0, SLC5/03=Node 1,
CTC PS10 Programmed, Loads. Still Working w/Tag Editor.
Method Of Madness vs Time, Been Wrong Before.
Most People Use Ch-0 On SLC5 For PC-Comm, I'am Using
1747-PIC On Ch-1 Cause I Still Have It and Not Sure About
Max Cable Lenght Restriction
Easier To Frabricate D-Shell's.
CTC HMI Located Aprox +20Ft From Processor
Thank You.