We are using Wincc HMI redundent server.Yesterday when i overserved , status of both server is MASTER.I restarted one server and the things become normal(status of #1--master , status of other - standby).I had some doubt so i restarted the other server also but then i found that the status of both server became again as master.Is there any special proceedure/seqence to reset/restart both servers.
Restart/reset HMI servers
- Thread starter panthripu
- Start date
Similar Topics
We have 5 machines each using a 418-2 CPU. 4 of the lines have automatic bleed off valves to purge gases which might accumulate during production...
Greetings all,
I have a general problem when using instance DBs with FBs in S7.
Upon a cold restart, the values in the instance DBs gets reset...
Hello all,
I am currently trying to program a PowerFlex 525, version 7.0. We had a power outage recently and when the power was restored, the...
How to fix if appears code “$115 plc-restart running” on the screen OP17
Hello everyone, I'm new here.
First of all I just want to say that you guys are very knowledgeable and reading your posts on here has saved my...