Drive ES Starter problem

Hey now i have bean looking for hours to solve this.

On the engineering station Drive ES starter v.4.1.1.2 installed
And there is some drives on the project already,
We use Sinamics S120 drives and CU320 and im going to setup 2 more drives that is identical the ones that already is in the project,

So a little tip where i can change this settings will make me happy

this is the parameter list from one that is up and running
As you can see P2042 and up it stands profibus.


And this is my new drive, and i cant found what i have done wrong,
i have:
IF1 PROFIDrive
binector-conector etc.
where i should have profibus

Are you adding another CU320 or just adding drives to an exisiting CU320 ?

If adding to an exisiting CU320 you can use copy/paste to add duplicate drives.

It´s a new CU with 2 double drive,
The CU is automatic generated from the HWconfig, so i cant just copy/past.
But i did copy/past the infeed and drives, i now i got this strange setup,

Everything worked ok with this setup,