quartet
Member
Hello all,
I am upgrading an Omron NT touch screen with an NS. The PLC is a CVM1-CPU21-V2. I am using an NS-AL002 422 converter. My screen information comes up but then I get a time out error. The touch screen is set to NT Link 1:1 and the baud rate on the port is set to 9.6. Not sure if my cable is correct. Does anyone know the pin out information that I need or know of anything else that is wrong?
I am upgrading an Omron NT touch screen with an NS. The PLC is a CVM1-CPU21-V2. I am using an NS-AL002 422 converter. My screen information comes up but then I get a time out error. The touch screen is set to NT Link 1:1 and the baud rate on the port is set to 9.6. Not sure if my cable is correct. Does anyone know the pin out information that I need or know of anything else that is wrong?