Mitsubishi nc - meldas c5

zai_jnr

Member
Z
Join Date
May 2008
Location
MALAYSIA
Posts
169
Hi members,

I'm now working to upgrade Aseries to Qseries PLC.
MELDAS C5 is NC(numerical controller) from Mitsubishi. Existing system, MELDAS C5 communicate with AJ1UC24. For AJ1UC24 i will replace with QJ71C24N.For MELDAS C5, I got problem to find solution to replace for this module. Please help me to propose what spec to use to replce for MELDAS C5? Seriously, I'm not familiar with NC equipment.:confused:

Thank you in advance for who reply to my question.
 

Similar Topics

Wasan
Request for Mitsubishi MELDAS MDS-A-CR-75 Manual
Hi everyone. My customer tell us to check their MDS-A-CR-75 that I have find some manual for a while but not found it. Are there anyone have...
Replies
2
Views
1,389
alysemast
A
B
Mitsubishi PLC4B MELDAS 500 CNC
Does anyone happen to have PLC4B and COMU sofware?
Replies
0
Views
1,814
[email protected]
B
ToolGuyFred
Mitsubishi Meldas CNC
I have a machine fitted with a Meldas 50 CNC which is refusing to start. I have a series of alarm messages on the controller which display in the...
Replies
0
Views
3,179
ToolGuyFred
ToolGuyFred
H
Mitsubishi FX3G PLC with Beijer HMI E615
Hello, I have a Mitsubishi FX3G 14M PLC and a E615 HMI from Mitsubishi/Beijer. I'm using GXWorks 2 to do the programming and I have no problem...
Replies
4
Views
147
NicoSz
N
S
MITSUBISHI ALPHA AL2-24MR-D Controller
Hello! If someone can help me with the following problem. I can't change the phone number. Do I really need the interface (AL-232CAB - Programming...
Replies
0
Views
69
soro4gsm
S
Back
Top Bottom