new for plc

jassy

Guest
J
Hi,

I have no experience with plc.

I have one plc MicroLogix1000(AB). I want to read program from that

PLC.for that my laptop need any software or not?

If it's need software then how I can get?

Thanks,

jassy
 
The software is called RSLogix500 and it is not free.
You can go to Rockwell Software website and obtain
demo version which should allow you to get taste of
full version.
 

Similar Topics

Voltimus
IDEC PLC to PLC modbus communication
Apologies for not being the best IDEC programmer. I recently was doing some inspections on a site that had 3 FC6A IDEC processors. The issue is...
Replies
0
Views
41
Voltimus
Voltimus
P
PLC MICROLOGIX 1000 AND 1761-NET-ENI
"Hello! Good day! Excuse me, I have a question regarding the 1761-NET-ENI. RSLinx has already detected it but it's not connecting to the PLC...
Replies
4
Views
78
roxusa
R
B
$115 plc-restart running, how to fix
How to fix if appears code “$115 plc-restart running” on the screen OP17
Replies
3
Views
102
parky
P
Rsflipflop256
Setting up a modbus network on a DL262 Directlogic PLC with Siemens LMV 3 Burner controllers as slaves, eight of them, with OCI 412.10 Interface
Good morning fellow sea captains and wizards, I am being asked to do the above and obtain 4 values from each slave, I know about the MRX and MWX...
2
Replies
20
Views
221
Rsflipflop256
Rsflipflop256
J
PLC SIMATIC S7 1200 / KOP/SCL question
HI i would like to know how to get a variable that will store the amount of times a program has been executed. The issue is I have 3 DBs for 1 FB...
Replies
2
Views
61
jimix
J
Back
Top Bottom