Hey folks!
I have a A173UHCPU (Motion Controller PLC)
I have reviewed the PLC program and found a section that is highlighted 'yellow'....and appears to jump over a lot of
instructions........
like :
4100: --| |------( )-
4102: ONLY YELLOW BAR VISIBLE
4277: --| |------( )-
(Program continues.......)
is there a special 'editor' I need for this? I tried looking around to discover what the bar is...and think it may be something called 'Microcomputer' code.......
but, I am at a loss on how to view it, edit it, or manipulate it.....
Any clues from the guru's?!!
-Steve
I have a A173UHCPU (Motion Controller PLC)
I have reviewed the PLC program and found a section that is highlighted 'yellow'....and appears to jump over a lot of
instructions........
like :
4100: --| |------( )-
4102: ONLY YELLOW BAR VISIBLE
4277: --| |------( )-
(Program continues.......)
is there a special 'editor' I need for this? I tried looking around to discover what the bar is...and think it may be something called 'Microcomputer' code.......
but, I am at a loss on how to view it, edit it, or manipulate it.....
Any clues from the guru's?!!
-Steve