SLC150 OTE866 ZeroCross TurnON

From the technical.pdf it said to minimize the triac output noise during loads switching. unfortunately it will effect the performance of the PLC.

program in SLC150:

--------------(866)

I'm trying to migrate the same function into MLX1200 (1746-L40AWA) using RSLogix500, but no idea how to configure/program it....

will it effect the performance of the PLC and how much will it effected.

Please help...

Since the MLX1200-L40AWA uses relays instead of triacs for the output I think you could just omit or skip this instruction completely. Someone else may know a better answer. I am adding a link to the ML1200/1500 reference manual so you can refer to it for more information. Page 101 gives an overview of the instruction sets.
Link to MLX1200 manual:
http://literature.rockwellautomation.com/idc/groups/literature/documents/rm/1762-rm001_-en-p.pdf

daggersiulee,

While Googleing on this subject, I came across this PDF that warns about doing this into an inductive load.

http://relays.tycoelectronics.com/appnotes/app_pdfs/13c3206.pdf