ERGOCONTROL NC IV on DEMAG made by SUGMATEK,Austria

renunil

Member
R
Join Date
Aug 2004
Posts
2
We have been using ERGOCONTROL NC IV on DEMAG Plastic Injection Moulding machines.

We are facing problems with HMI of the ERGOCONTROL systems.

We need help to source components / repair the same.

Any Help regarding this shall be highly appreciated.

Thanks & Regards,

RENUNIL
+234 813 321 8765 Or +1 408 789 7070
 

Similar Topics

Z
FX series PLC and Hoist Demag model F24-8D
Hello buddies, I'm now working with hoist demag model number F24-8D and PLC mitsubishi FX series. Currently the hoist was movement control by...
Replies
6
Views
4,464
zai_jnr
Z
W
AB slc 150 how to write program for demag crane
Just finished installing a 10 ton demag crane. The crane should have three speeds for the bridge and trolley but they do not work. The only speeds...
Replies
14
Views
5,725
jrwb4gbm
J
J
German made 4 wire analog pressure transmitter 0-10v
Does anyone have experience wiring this type of analog pressure transmitter up? It's 4 wires. 3 blacks and 1 green which I assume is earth...
Replies
9
Views
259
JoeM61
J
T
I made a PLC AI assistant that references manuals
I think it's really tedious to dig through long manuals so I made an AI tool that can: - Answer questions about parts without digging through...
Replies
9
Views
1,718
ASF
A
R
Free and open-source PLC driven warehouse/manufacturing simulation made with Unity
GitHub Link: https://github.com/Automation-Standard/Open-Industry-Project This is a little side project I've been working on that I felt would be...
Replies
14
Views
3,417
ryevdokimov
R
Back
Top Bottom