please help me in g-file configuration

please help me as soon as possible

i have redundant plc

i have duty plc ,chasies 4 slot , slot0 1747-l553, slot1 1747-bsn .

and

i have Stand By plc ,chasies 4 slot , slot0 1747-l553, slot1 1747-bsn .


and distrebuted i/o throw RIO protocol

first rack 1794-ps3 , 1794-asb , 1794-ib32 , 1794-ie12 , 1794-ie12 , 1794-ie12 , 1794-ie12 , 1794-oe12 , 1794-oe12 , 1794-oe12



second rack 1794-ps3 , 1794-asb , 1794-ib32 , 1794-ib32 , 1794-ib32 , 1794-ib32 , 1794-ib32 , 1794-ib32 , 1794-ib32



thierd rack 1794-ps3 , 1794-asb , 1794-ob16 , 1794-ob16, 1794-ob16, 1794-ob16, 1794-ob16, 1794-ob16


fourth rack 1794-ps3 , 1794-asb , 1794-ob16 , 1794-ob16, 1794-ob16, 1794-ob16, 1794-ob16, 1794-ob16





please help me how make g file as soon as possible .please please .

I have never set up a BSN, but perhaps this will help.

User Manual:

http://literature.rockwellautomation.com/idc/groups/literature/documents/um/1747-um010_-en-p.pdf

Configuration is in chapter 5.

Installation:

http://literature.rockwellautomation.com/idc/groups/literature/documents/in/1747-in015_-en-p.pdf

Presumably, you would set up your G file to match your rack settings for starting group and size. Normally, there are a maximum of 31 Input/Output words, as one each is used for Status/Control.
Both BSN Modules should have the same setup in them.

Stu.......

thank for reply but i can not understand this idea ......

please can you describe more and more

Well, I don't know how you have your system set up, and your ASB settings. If you have set up the first Rack as Logical Rack 0, your second rack is Logical Rack 1, your third rack as Logical Rack 2, and your last rack as Logical Rack 3. Based on the I/O you listed.

In your G File select Logical Rack 0, and make it a full rack with the drop down box. The same for Logical Rack 1. For Logical Rack 2 and 3, select them, and make them a 3/4 Rack.

I have never used 32 Point cards on a SLC500 or 1794 I/O. So, I am not sure of the I/O Data Addressing ramifications of this. You have a lot of 32 point cards, and Analog I/O. You will have to research the proper setup.

Perhaps someone with experience in this will jump in.

Good luck.

Stu.....