Changing bit in STEP 7 with some frequency
- Thread starter Adenitz
- Start date
TurpoUrpo
Lifetime Supporting Member
HW config, cpu properties, assign clockbyte.
L D[AR2P#0.0]
Lifetime Supporting Member
set the M byte number here for the clock byte:
Thank you L D[AR2,P#0.0], I have set this byte MB 0.
Now I can see that all bits M0.0 to M0.7 blinking at different frquency.
I'm pretty much sure about M0.7. It is blinking in such way that 1 is present for 1 sec and pause is also 1 sec,so overall period is 2 sec.
How to determine the rate blinking of other (faster) bits?
Thanks
Now I can see that all bits M0.0 to M0.7 blinking at different frquency.
I'm pretty much sure about M0.7. It is blinking in such way that 1 is present for 1 sec and pause is also 1 sec,so overall period is 2 sec.
How to determine the rate blinking of other (faster) bits?
Thanks
TurpoUrpo
Lifetime Supporting Member
Look at help, it gives all of bits blink rates, they are always same amount off and on. Mx.0 = 100ms, Mx.1 = 200ms. Rest look at help.
KalleOlsen
Member
Steps:
A: Get a PLC that can do a 5ms time interrupt task.
B: Put in this code (IL)
AN Togglebit
= Togglebit
C: Done! Coffee time!
Kalle
Similar Topics
Hi,
I am using the DN bit to stop the timer. However the DN bit doesnt change state. Please see the attached image. Any help is appreciated.
Hi,
I am creating a HMI project that is using kepware OPC server to communicate with a square D PLC.
I need to create something like a...
Hi
Just have a quick question, I am updating HW config of a system which uses a few DI / RO and AI inside with an ET200S.
Card one uses byte...
Hi
How can I set a value(like something in MW0) with both PLC and HMI?
How can I program this:
I have 16 alarms in a word. When a there is an alarm, I want to detect this, so I compare it with zero. When there is a...