Coms Help RSLinx to 1747-UIC USB

Both hardware and software have be running on this PC. But I had to format my hard drive for other reasons so am re-installing right now and im having big bother.

RSLogix 500 5.20.00
RSLinx Lite 2.30.01 build 48
PC to SLC5/01 Interface is USB Converter 1747-UIC Ser A Rev D Frn 1.3

Note I installed 1747-UIC Driver FTDI 1.0.2115.0 Prior to Installing RSLinx.

When I drill down to available drivers:
RSLinx Lite/Communications/Configure Drivers/Available Drivers

The DH485 option does not appear, I cant figure out how to add it

can any one help please before my remaining hair is pulled out.

mg

Read the manual

Here's a link to the pdf manual
http://literature.rockwellautomation.com/idc/groups/literature/documents/in/1747-in063_-en-p.pdf

Sorted

mg

Upload a new version of RSLinx 2.53 or newer (its free)

http://www.rockwellautomation.com/support/webupdates/

Also see the pdf for a procedure that we send with our UIC cable... this may also help www.plctrainer.net/1747UICProcedure.pdf

Here are the drivers for the UIC if needed http://www.rockwellautomation.com/support/pccards/

Regards
Mark