I have a ML1200 with 2 serial ports. Channel 0 is configured for modbus communications with a motion controller.
The programming / HMI port is set up for DF1 full duplex (not congigurable).
My question is, is it possible for a PV+ to communicate with the ML1200 via the PV+ serial port to ML1200 prog/HMI port?
I'm not having any luck, the PV+ DF1 node shows up in RSLinx Enterprise (when my laptop is connected to PV+ via ethernet), but no device shows up to create a shortcut.
Thanks for any help,
Rob
The programming / HMI port is set up for DF1 full duplex (not congigurable).
My question is, is it possible for a PV+ to communicate with the ML1200 via the PV+ serial port to ML1200 prog/HMI port?
I'm not having any luck, the PV+ DF1 node shows up in RSLinx Enterprise (when my laptop is connected to PV+ via ethernet), but no device shows up to create a shortcut.
Thanks for any help,
Rob