PLCSIM V4.0 & WinCC V6.0 SP2

hagos

Member
H
Join Date
Oct 2004
Location
Africa
Posts
244
Hello sparkies,

I'm trying to connect a PLCSIM V4.0 to a WinCC V6.0 SP2,I did every thing possible but without success.

My question is: Can the PLCSIM 4.0 connects to the WinCC 6.0 SP2?

I appreciate your help very much.

Regards
Hagos
 
Thanks Saperov,

But is it possible to let the PLCSIM 4.0 communicate with WinCC V6.0 SP2?

Regards
Hagos
 
I haven't installed PLCSIM v4.0 and WinCC v6.0 - its very very old programs(program of the past millennium).
PLCSIM v5.* and WinCC v6.* work fine.
 

Similar Topics

Iman
PLCSIM+Nettoplcsim+WinCC
Hey guys, I've two computers. One of them is my PLC (PLCSIM + Nettoplcsim) and the other one is my HMI (WinCC V7). I've adjusted many settings...
Replies
2
Views
3,505
Thomas_v2
T
S
wincc named connection plcsim
Dear Expert, I want to test my project in PLCSIM using "Named Connection" driver in WinCC.how can i do this? Is there any way to insert tags from...
Replies
1
Views
2,524
seee
S
F
Wincc flexible 2008 and PLCSim connection.
Hi all specially step7 guys, so I have been training and getting used to Step 7 Suite, and so far I like it, a bit different from RS logix but not...
Replies
6
Views
4,076
fredz0003
F
I
Simulation between S7 , S7-PLCSIM and WinCC Flex 2005
Hello ! I made a very simple program in s7 (only 1 FC) where a motor starts and stops through push buttons. I just want to simulate it in WinCC...
Replies
6
Views
5,688
interlock
I
H
WInCC & PLCSIM V5.4
Dear Folks, Has any of you get the WinCC V6.0 SP4 communicating to PLCSIM V5.4 ?Mine is not working so I have to install PLCSIM V5.3 which is...
Replies
2
Views
3,045
hagos
H
Back
Top Bottom