GE Fanuc DeviceNet Master used as a Slave

I am trying to use a GE Fanuc IC695DNM200 Master module as a Slave to a DeviceNet LAN. The module datasheet says that this can be done, but I am not sure if it can be done with anything other than another GE Master. Any tips on how to configure this module in Proficy ME v5.8? Thanks

Figured it out. I needed to Open the Network Settings for the IC695DNM200 Module, then go to the Connection 1 tab, than change the Connection to POLLED and set the Input & Output Resources to the number of bytes that the module was going to Produce/Consume. Sounds easy now.