First i would like to say that this is a grat site. I was viewing the thread on the Dual Compressor Simulation for Logixpro. I have run 150 mph into a brick wall on this one. I dont understand how Exersise 2. Is it possible to toggle the compressors without using the second pressure switch? i normally would not want hints but i am progressing through the simulations and for some reason i cannot even get started on switchiing between two compressors without timers or counters or the second pressure switch . Seeing as how this topic has allready disscussed i understand if yall just redirect me to the previous thread. Kudos to all the pros here who give advice on this sit, i am really impressed with your involvment in this industry. Thanks!!
Revisiting Dual Compressor Simulation for Logixpro
- Thread starter brennan84
- Start date
Similar Topics
Hi,
I would like to assemble a simulator/practice booster pump system that uses PID to maintain steady water pressure under various outlet demands...
Currently we have a fat( I think that is what it is called) Intouch application. An application resolution of 3840x1080, and inside that 2x...
Hi
I am being given several fault words (as a DINT) from a Drive that I am receiving into a Compactlogix L33ER controller. I have a small...
Hi everyone. Ifix scada is new for me. Please help help me to clarify is it possible to open Ifix scada runtime on dual monitor and how to do? Thanks
I am passing DINTs between a Micro800 and CompactLogix - each bit in the DINT has its own unique meaning.
On the Studio5000 side I can just write...