about omron interrupt routine`s

deshmukh jagannath

Member
D
Join Date
Apr 2010
Location
pune
Posts
6
hallo everybody,
i`am not getting how to enable the interrupt routine`s in omron CQ1MH series.either any input bit`s to enable or any interrupt instruction?
 
Have you looked at the W364 manual Section 1-4?

This manual can be downloaded from the Omron website.

Section 1-4 details the different types of interrupts and how to configure the processor.

Hope this will help.
 

Similar Topics

E
Omron Input Interrupt Performance
We are using an Omron CQM1-CPU45 and CQM1H-CPU51 (w/ SYSWIN 3.4) and we are trying to implement an input interrupt function. We've gotten the...
Replies
4
Views
4,818
ed yeh
E
K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
6
Views
206
KalvMavin
K
M
Struggling to get good connectivity with Omron PLC (CS) and KeserverEx
Hi There, I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Replies
4
Views
129
Mihir_007
M
A
Omron cj1m ETN cpu11 connection with NT631C
Hi dear . I have a system with cj1m cpu11 etn. previously NT 5z HMI was connected with plc. recently my old HMI got damaged. I want to replace it...
Replies
11
Views
223
ali1122
A
K
Omron AD081-V1 Analog Input Card Calibration (Offset & Gain Adjustment)
Omron AD081-V1 Analog Input Card Offset & Gain Adjustment Entering Adjustment Mode 1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...
Replies
0
Views
80
Ko Lin
K
Back
Top Bottom