BRETT EPPERLEY
Member
- Join Date
- Oct 2003
- Posts
- 5
HOW DO YOU GO ABOUT TOTALIZING GPM FROM A 4-20ma SIGNAL I AM USING DIRECTSOFT32. I ALREADY HAVE THE SIGNAL CONVERTED TO GPM.
4-20ma FLOWMETER NEED TO TOTALIZE GPM
- Thread starter BRETT EPPERLEY
- Start date
ArikBY
Member
Orn Jonsson
Member
Average and add average and add..........
Average the Flow Every Minute (10-20 samples depending on the accuracy you want) then put the numbe aside (in reg.) a minute later you will have another average flow for the minute which just passed. Add that to the last nuber etc.......
O Jonsson
Average the Flow Every Minute (10-20 samples depending on the accuracy you want) then put the numbe aside (in reg.) a minute later you will have another average flow for the minute which just passed. Add that to the last nuber etc.......
O Jonsson
Similar Topics
Just wondering if it is possible to wire in a Cynergy UF08B100 Flowmeter into an Allen Bradley 1734-IE4C.
I have tried every way I can think of...
Hi,
I have a 4-20mA Electromagnetic Flow meter which is externally powered. I have a 24VDC supply powering the meter (which is powering up...
Hi all,
I'm connecting several 4-20mA sensors together in parallel (only one shown below) The enclosure is ABS plastic with metal backplate
DAQ...
Problem:
Our PLC can only output 4-20mA, but the actuators it needs to control, modulate based on a 0-135Ohm signal. Buying 4 or 8 individual...
What's your go to 4-20ma isolator. I've got some 4 wire 4-20ma from several flow meters and scales that I would like to isolate before it gets to...