dtikasingh
Member
I am trying to talk to a Control Logix PLC via Citect SCADA.
This is the first project I am doing with CitectSCADA and I am not sure what is required. Thus far my set up is as follows:
Board1:
Board Type - ABCLX
Address - 0
Port1_Board1:
Port # - 1
Special Opt - 10.10.1.1/0 (Adress of PLC & /0)
I/O Device:
Number - 1
Protocol - ABCLX
Memory - FALSE
-------------------------------------------------
What am I doing wrong or what else do I check for as I keep getting a hardware error when I go online.
This is the first project I am doing with CitectSCADA and I am not sure what is required. Thus far my set up is as follows:
Board1:
Board Type - ABCLX
Address - 0
Port1_Board1:
Port # - 1
Special Opt - 10.10.1.1/0 (Adress of PLC & /0)
I/O Device:
Number - 1
Protocol - ABCLX
Memory - FALSE
-------------------------------------------------
What am I doing wrong or what else do I check for as I keep getting a hardware error when I go online.