Good evning,
Today i was going to add a new profibus nod to a system
it´s a 6ES7151-1CA00-3BL0 Siemens ET200s IM151-1 comapct.
The module have been in the cabinet for some years and no one have connect it with 24VDC or to the profibus.
Now we need that one, i add it to the HW config,
set the right profibus adress to HW config and the ET 200s module.
switched on the power and the BF blinks and SF is ON.
i open HW config online and i cant connect to the node.
I have never used a IM151-1 comapct before
And i think that with this system you can expand with more i/o and there should be a terminating module at the right side of it,
is that right?
Today i was going to add a new profibus nod to a system
it´s a 6ES7151-1CA00-3BL0 Siemens ET200s IM151-1 comapct.
The module have been in the cabinet for some years and no one have connect it with 24VDC or to the profibus.
Now we need that one, i add it to the HW config,
set the right profibus adress to HW config and the ET 200s module.
switched on the power and the BF blinks and SF is ON.
i open HW config online and i cant connect to the node.
I have never used a IM151-1 comapct before
And i think that with this system you can expand with more i/o and there should be a terminating module at the right side of it,
is that right?