Mitsubishi Servo Deviation Counter??

tmiuser

Member
T
Join Date
May 2009
Location
Kentucky
Posts
26
I am noticing on a Q173 servo system that all of them have an
'Deviation Counter Value' that usually reads in the 80,000 to 130,000 range.....(positive and negative....)

the system is running, but I'd like to know what causes this?
(or....is it normal?)

ugh!!

-Steve
 

Similar Topics

D
Control Servo mitsubishi using FB
Hi everyone. I try to using FB MC_MoveAbsolute, but Fb was error [1103 A value out of the range is set as a commanded position or travel...
Replies
7
Views
822
parky
P
A
mitsubishi plc - servo problems
we have a pipe cutting machine that was out of use for a long time, so the battery for plc was gone. I replaced plc battery, but now both servo...
Replies
1
Views
1,006
parky
P
M
Mitsubishi Servo Drive Selection
Hi I selected a Mitsubishi Servo drive MR-J4-100TM-PNT for profinet communication. The supplier I am getting from this particular drive doesn't...
Replies
1
Views
1,398
parky
P
A
Servo motion for pulse/direction in Mitsubishi FX3 vs FX5
I’m fairly new to PLC programming. This is our first machine that uses an FX5 PLC rather than an FX3, and therefore GX Works3 instead of GX...
Replies
1
Views
1,243
parky
P
R
Mitsubishi Servo Drive
We have an OLD Mitsubishi servo drive MR-H22KAN-S300. What does S300 Means, i didn't find any information about s300 on the internet. Any one can...
Replies
2
Views
1,383
goghie
G
Back
Top Bottom